Thomson SpeedTouch 716 v5 WL

From GPLdevWiki

The Thomson SpeedTouch 716 is an ADSL2+ CPU with intergrated VoIP IAD

Contents 1 Documentation 2 Hardware 2.1 serial port 2.1.1 boot log

Documentation

• http://www.speedtouch.co.uk/downloads/716/r5/ST716v5_InstallSetup_en.pdf

Hardware

The hardware is based on the following chips:

• Broadcom BCM6348KPB single-chip ADSL2+ CPE
  • http://www.broadcom.com/products/DSL/xDSL-CPE-Solutions/BCM6348
  • http://www.broadcom.com/collateral/pb/6348-PB01-R.pdf
• Broadcom BCM5325MA2KQM unmanaged 6port 10/100BaseT switch
  • http://www.broadcom.com/products/BCM5325
  • http://www.broadcom.com/collateral/pb/6348-PB01-R.pdf
• Broadcom BCM3341A0KPB VoIP broadband IC
  • http://www.broadcom.com/products/Cable/Cable-Modem-Solutions/BCM3341
  • http://www.broadcom.com/collateral/pb/3341-PB04-R.pdf
• Legerity Le9502BTC two channel rining subscribe line IRC (RSLIC)
  • http://www.legerity.com/products.php?cid=&sid=13&bpid=46
  • http://www.legerity.com/getfile.php?bpd_163_DS_Le9502_G3_ID081007.pdf

• BCM4318KFBG based WiFi miniPCI card

serial port

There's an unpopulated header 'J5' on the PCB. It's pinout is as follows:

1. +Vcc
2. GND
3. TxD
4. RxD

boot log

Unzipping started

 UNZIP DONE -> starting bootloader 


 Speedtouch initialization sequence started.

Secondary boot

Unzipping started

 UNZIP DONE -> starting uncompressed file 


 Speedtouch initialization sequence started.
�

[OSI2]  File "/ZZR8AA5.335": Format OSI2 compliant (offset=340, prodid="0", varid="0").
[SS]    Device mounted (prodid="0", prodname="SpeedTouch 716", varid="0", varname="").
[ELF]   Loading file "/ZZR8AA5.335" ...
c

 Speedtouch initialization sequence started.
ETHD: external phy is used
b6w_init
Calibrating delay loop... 253.13 BogoMIPS
mpi: device 0x4318 found in PCI slot 1, function 0
archfs opened /ZZR8AA5.335 offset 1881475
ADSL PHY version is A2pBT008_rc1.d16f
ETH: Device registered: BCM6348-E#0.
ETH: Device registered: BCM5325#0.
ETH: Interface 0 assigned: BCM5325#0:0 [external].
ETH: Interface 1 assigned: BCM5325#0:1 [external].
ETH: Interface 2 assigned: BCM5325#0:2 [external].
ETH: Interface 3 assigned: BCM5325#0:3 [external].
ETH: Device registered: SBRIDGE#0.
ETH: Device registered: BCM6348-U#0.
ETH: Interface 4 assigned: BCM6348-U#0:0 [external].
3.91.41.0: Broadcom BCM4318 802.11 Wireless Controller
ETH: Device registered: BCM6348-W#0.
ETH: Interface 5 assigned: BCM6348-W#0:0 [external].
ETH: Interface 6 assigned: BCM6348-W#0:1 [external].
ETH: Interface 7 assigned: BCM6348-W#0:2 [external].
ETH: Interface 8 assigned: BCM6348-W#0:3 [external].
ETH: Interface 9 assigned: BCM6348-W#0:4 [external].
ETH: Interface 10 assigned: BCM6348-E#0:0 [internal].
ETH: Interface 11 assigned: BCM5325#0:8 [internal].
ETH: Internal connection: intf 11 <-> intf 10.
--- REGISTERING STREAM : ROUTING ---

************* ERROR RECORD *************
time            : 000000:00:00.000000
Application /ZZR8AA5.335 started after POWERON.
****************** END *****************
Username :